Drone capability. On demand. Anywhere.

DropForce production cells build STURM 01 drones at the place of use. The Tactical Case is a rugged case with a 3D printer built in. It prints the parts for each drone and the module mounts for the mission, and the pre-configured kit is assembled with them. One drone every 20 minutes.

Request a briefing How the cell works

Production cells

Cycle time: 20 min per drone
Tactical Case: 70+ / 24 h
Tactical Van: 120+ / 24 h
Tactical Container: 200+ / 24 h

Tactical Case: design rate, calculated from the 20-minute cycle.

Buying drones and having drone capability are not the same thing.

A conventional build takes 4 to 8 hours per drone, by specialists, in a central workshop. A Tactical Case with kits in stock builds one every 20 minutes, where the drones are used.

Two ways to get drones.

A few drones: order them from us. Ten or more a month: keep our factory where you operate.

How many drones a month?12

Order STURM 01

We build it and ship it assembled.

Send a reservation request

Keep the factory on site

The case prints parts and module mounts, the kit is assembled with them. Lost drones are replaced on site, and you buy kits, not finished drones.

Compare the production cells

Cycle time per drone: 20min
Tactical Case, design rate: 70+/ 24 h
Solder joints at assembly: 0

Build time for one drone

DropForce Tactical Case 20 min

Conventional build 4–8 h

Illustration. The Tactical Case prints the parts for one drone every 20 minutes; assembly runs alongside, no soldering. A conventional build takes 4 to 8 hours per drone; the bar runs at 4 hours.

The factory comes to where the drones are used.

Three cell sizes run the same process. Each cell prints the parts and the kit is assembled with them. Assembly needs no soldering.

Upright rugged case with its front door open and a 3D printer built into the interior, in a dark hall.

Tactical Case 20 min per drone · design rate 70+ / 24 h

Tactical Van seen from the rear left at dusk, both rear doors open, a row of lit 3D printers inside.

Tactical Van 120+ / 24 h · mobile

Tactical Container at dusk by a birch wood, doors open, lit workshop inside.

Tactical Container 200+ / 24 h · stationary

Design rate calculated from the 20-minute cycle.

Production cells in detail

STURM 01

The FPV drone every cell builds. Flight controller and ESC on one board of our own, manufactured in Europe. Open-source flight stack. Printed parts, no soldering.

STURM 01 in detail